0

Out of 0 Ratings

Owner's of the Frigidaire Range Frigidaire Electric Range gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 55
 
12
Surface cooking settings
The size and type of utensil used, and the amount and type
of food being cooked will influence the surface element
power level setting needed for best cooking results.
Use Table 1 to determine the correct setting for the type of
food you are preparing.
The size and type of cookware used will influence the
setting needed for best cooking results.
Table 1: Recommended settings for surface elements
Setting Type of Cooking
HIGH (HI) Start most foods; bring water to a boil and
pan broiling.
MEDIUM
HIGH (8-10)
Continue a rapid boil; frying, deep fat
frying
MEDIUM (6) Maintain a slow boil; thicken sauces and
gravies; steaming vegetables
Medium
LOW (2-4)
Keep foods cooking; poaching and
stewing
LOW (LO) Keep warm, melting and simmering
Radiant elements have a limiter that allows the element to
cycle on and off, even at the HI setting. This helps to
prevent damage to the ceramic smooth top. Cycling at the
HI setting is normal and can occur if the cookware is too
small for the radiant element or if the cookware bottom is
not flat.
For efficient cooking, turn off the element several minutes
before cooking is complete. This will allow residual heat
to complete the cooking process.
NOTE
NOTE
Start most cooking operations on a higher setting and
then turn to a lower setting to finish cooking.
A glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is
too small for the surface heating area.
The size and type of utensil used, and the amount and
type of food being cooked will influence the settings
needed for best cooking results.
The surface control knobs do not have to be set exactly
on a particular spot. Use the graphics provided as a guide
and adjust the control knob as needed. Each surface
element provides a constant amount of heat at each
setting. Refer to
Table 1 for suggested power level
settings.
IMPORTANT
NOTE
SETTING SURFACE CONTROLS