0
Owner's of the Electrolux Range Electrolux Electric Range gave it a score of 0 out of 5. Here's how the scores stacked up:
15
Setting the dual elements
The right rear and both right
and left front elements may be
set to heat as single or dual
elements.
Fig. 2
inner portion
heats only.
Fig. 3
inner and middle
portions will
heat.
To operate a dual radiant surface element:
Example
Step Press
1. Place cookware center on the
surface element.
2. Press and hold the ON·OFF key for
the desired element position until a
tone sounds.
3. Press +, med (5.0) or -. Each touch
of the + or - key will decrease or
increase the power level by 0.5
between 9.5 and 3.0. Simmer
power levels between 3.0 and 1.2
will decrease or increase by 0.2
increments. Lo is the lowest power
level available.
4. Use the size key to toggle between
the inner single heating element
(Figure 2) or to expand for dual
element heating (Figure 3-), then
release.
5. When finished, press ON OFF key
to turn element off.
-,
med,
+
ON·OFF
ON·OFF
size
Use the Suggested cooktop power level
settings table (Figure 1- previous page) to
determine the best element power setting for the
type of food you are preparing.
Cooktop power level settings
IMPORTANT
Do not allow aluminum foil, plastic, or ANY
material that can melt to make contact with the
ceramic glass cooktop. If these items melt on
the cooktop they can damage the ceramic
cooktop.
NOTE
Any heating zone may be set again and used for
cooking even if the HE message is displayed.
Fig. 1
Hot Element (HE) Message
After heating using any of the cooktop elements,
the cooktop will become very hot. Even with all
the controls off, the cooktop will remain hot for
some time afterwards.
The controls monitor the
temperature of the cooktop
surface. If the message "HE" (hot
element) shows in the cooktop
display window, then the cooktop
is too hot to touch (Figure 1).
size
size
• Start most cooking operations at a higher heat
setting and then turn to a lower setting to
finish cooking.
• For efficient cooking, turn the surface element
OFF several minutes before cooking is
complete. This will allow residual heat to
complete the cooking process.
• A glowing red surface heating area extending
beyond the bottom edge of the cookware
indicates the cookware is too small for the
surface heating area.
• Radiant elements have a limiter that will make
the element cycle ON and OFF, even at the
high setting. This helps prevent damage to the
ceramic smoothtop. Cycling at the high setting
is normal and will occur more frequently if the
cookware is too small for the radiant element
or if the cookware bottom is warped.
NOTES
Setting Surface Controls
Find Your Products By Category
Please Login
